BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 153

tor filter. Install new crush ring and O-rings. Lubri-
†
cate O-rings with STP Oil Treatment.
1. Adaptor
1. Crush ring
2. O-rings
Install injector into mount housing. Press on injec-
tor face until injector seats in mount housing.
FUEL COMPONENT SERVICING
Installation
NOTICE
All injectors must be installed in the
correct cylinder by serial number. Improper
injector installation can result in powerhead
failure.
Installation of a replacement injector requires that
coefficient data for the new injector is uploaded to
1
the EMM.
Coefficient data for some replacement injectors is
supplied on a computer disk shipped with the
injector. If a disk is not included with the injector,
coefficient data can be downloaded from the
002196
Evinrude/Johnson dealer website. Refer to the
instructions provided with the injector kit.
Upload Coefficient Files to EMM
2
Use the Evinrude Diagnostics software Settings
screen to upload the coefficient file to the EMM.
1
Select the Injectors tab.
Select the cylinder tab for injector being replaced.
Select the Replace Injector button.
002317
1
1. "Replace Injector" button
002318
FUEL SYSTEM
7
008118
151