BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 176

OILING SYSTEM
OIL CONTROL SETTINGS
Use the Prime Oil System button of the Dynamic
Test screen to prime the oil pump.
Dynamic Test Screen
1. Prime Oil System button
Observe oil flow through all oil distribution hoses.
Air must be purged during the priming procedure.
60° V4–V6 Models
1. Oil distribution hoses
174
Make sure that oil flows through the rear oil distri-
bution manifold to the cylinder block fittings.
1
1. Rear oil distribution manifold
008092
Small bubbles are acceptable. Large bubbles
must be eliminated through continued priming.
1
1
3
1. Oil distribution hose
2. Small bubbles
3. Large bubbles
Repair any fuel or oil leaks.
The oiling system on these models can also be
004965
primed using the Self-Winterizing feature if diag-
nostics software is not available. Refer to STOR-
AGE on p. 43.
008016
2
004398
1