BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 128

ELECTRICAL AND IGNITION
CONNECTOR SERVICING
P T S
OWER IMER ERIES
The J2 connector of the EMM is a AMP Power
Timer Series connector.
Disconnect
Use a screw driver to open latch. Pull connector
from plug.
Connect
Push connector until seated in plug. Close latch
completely.
1
2
1. J2 connector
2. Latch (closed)
Terminal Removal
Use Terminal Release Tool, P/N 351413, to
release BOTH locking mechanisms of connector.
Pull terminal from housing.
1. Locking mechanism(s)
1. Terminal release tool
126
Terminal Installation
Align terminal with connector housing and push
terminal with seal into connector housing until
seated.
2
1. Latch
2. Terminal with seal
Packard Connectors
IMPORTANT:
test probes and adapters when testing compo-
002120
nents fitted with these terminals.
Disconnect
Lift latch(s). Remove connector.
Connect
Confirm the seal is in place. Push connector onto
1
housing until latched.
1
002455
002313
Always use the appropriate meter
1
002456
DSC02124