Trim Rod Removal - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Clean any thread-locking material from the
threads on the inside of the nut. Spray threads of
with Locquic Primer and let dry. Apply a small
amount of Nut Lock to the threads. Slide the
washer over the threads and install the nut.
Torque to 58 to 87 ft. lbs. (79 to 118 N·m).
To ensure that the tilt piston has been properly
assembled and the impact relief balls are properly
seated, apply Power Trim/Tilt & Steering Fluid on
top of the tilt piston. Fluid should not leak past the
impact relief balls while seated. If fluid does leak,
disassemble the piston assembly and inspect the
relief ball seats. Set the tilt rod assembly aside.
SERVICING – THREE PISTON SYSTEM

Trim Rod Removal

Unscrew trim cylinder end caps using Trim Cylin-
der End Cap Remover/Installer, P/N 436710, or
Universal Spanner Wrench, P/N 912084, and a
breaker bar. Small pins must be used in the span-
ner wrench.
41783
Slide the caps to the end of the rods. Drain the
fluid from the top of the pistons.
41828
Slowly pull each piston out with a rag wrapped
around the rod and the top of the cylinder.
TRIM AND TILT
41829
41837
13
41838
353