BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 199

Disconnect power trim connectors.
1
1. Tilt limit switch connector
2. Sending unit connector
1. Tilt relay connector
Remove pin and washer from shift rod lever to
release the lower shift rod.
1. Shift rod pin
Disconnect electrical harness from exhaust valve
actuator (V4 models). It is not necessary to
remove actuator from exhaust housing.
2
1
005254
1. Actuator connector
Disconnect water overflow hose from vapor sepa-
rator. Remove clamps and muffler assembly from
rear of powerhead.
1
1
005255
1. Overflow indicator hose
2. Muffler clamps
Install Lifting Fixture, P/N 342672, on crankshaft.
Tighten mounting screw securely using an Allen
1
1/4 in. hexagonal wrench.
005253
POWERHEAD
POWERHEAD REMOVAL
005247
005243
005260
2
10
197