BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 254

Table of Contents

STERN BRACKET

Install the tilt limit switch and retainer on the swivel

bracket. Tighten screws to a torque of 40 to 50 in.

lbs. (4.5 to 5.5 N·m).

1. Tilt limit switch

Route the trim sender wires through the braided

tube, and install the sender unit in the port stern

Install the upper and lower steering shaft bushings

and new seals in the swivel bracket. Both seal lips

Coat the outside surfaces of seals with Gasket

Sealing Compound.

Coat the bushings and seal lips with Triple-

Guard grease.

Coat tilt tube bushings with Triple-Guard grease

and, if removed, install them in the swivel bracket.

Place the swivel bracket between the stern brack-

ets and install the anode.

Install the tilt tube and tilt limit cam. Refer to TILT

TUBE on p. 240.

30765 / 30764

Chapters

Table of Contents