BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 351

Table of Contents

Remove the four screws securing motor to pump

manifold assembly.

Remove the wire shield from the pump manifold.

Remove the motor and inspect the motor O-ring

and the O-ring on the cable connector.

Remove and inspect the coupler. Remove the fil-

ter screen from the pump manifold. Check the

machined surfaces on the manifold for nicks and

scratches. The pump manifold is not serviceable.

Do not remove the pump or any control valves

from the manifold. Clean the screen with a mild

SERVICING – THREE PISTON SYSTEM

solvent and inspect it for tears, clogging, or other

2. Filter screen

Remove the three Allen head screws securing the

pump manifold assembly to cylinder body.

fold assembly are not available separately. Do not

remove pump or any control valves from the body.

TRIM AND TILT

Individual parts in the pump mani-

Chapters

Table of Contents