Trim Rod Assembly - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

TRIM AND TILT

SERVICING – THREE PISTON SYSTEM

Drain the remaining fluid from the cylinders.

Inspect both bores of the trim cylinders for exces-

sive scoring. If one or both trim bores are scored

or damaged, the hydraulic assembly must be

Remove and discard both back-up rings and the

O-ring from each trim rod piston.

P/N 983213, clamp the rod tightly in a vise.

Remove the thrust pad from the trim rod, then

remove the end cap.

Remove the rod from the vise. Use a small screw-

driver to carefully pry the scraper out of the end

cap. Discard the scraper.

Use a suitable tool to remove the inner quad-ring

and the outer O-ring. Discard the quad-ring and

Trim Rod Assembly

Lubricate and install a new quad-ring and scraper

in the end cap. Install the scraper with the bevel

facing out. Lubricate and install a new O-ring on

the outside of the end cap.

Table of Contents