BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 123

Align the starter frame and make sure the long
alignment mark matches the mark next to the pos-
itive terminal stud on the gear housing.
Push the armature down firmly and slide the
frame into place. Align the notches in the gear
housing and frame.
Install insulator cap on end of shaft.
Apply a light coat of Moly Lube to the end cap
bearing, and install the end cap.
ELECTRIC STARTER SERVICING
Install the two thru-bolts. Tighten to a torque of 50
to 65 in. lbs. (5.6 to 7.3 N·m).
Lightly coat the drive gear with Triple-Guard
grease, and install it on the armature shaft. Install
the retaining ring (flat side up) with No. 2 external
retaining ring pliers.
30352
30354B
Lightly coat the gear housing bearing with Moly
Lube. Lightly coat the driven gear with Triple-
ELECTRICAL AND IGNITION
30363
6
30366
121