BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 350

TRIM AND TILT
SERVICING – THREE PISTON SYSTEM
Screw the manual release valve in. Remove the
retaining ring using retaining ring pliers. Remove
the manual release valve.
Inspect O-ring and two plastic split rings on the
manual release valve for nicks and cuts. Inspect
tip of valve for damage. The two plastic split rings
are not available separately. If rings are damaged,
replace the manual release valve.
2
1. O-ring
2. Plastic split rings
Remove reservoir cap and drain the fluid into a
container. Inspect the O-ring in the cap.
1. Reservoir cap
348
Remove the three Pozidriv screws securing the
reservoir to cylinder body. Remove reservoir.
41739
Remove the reservoir O-ring from the cylinder
body. Check machined surfaces for nicks and
scratches.
1
1
1. O-ring
22863
Use a 6 mm hex wrench to remove the plug from
the cylinder body. Inspect the O-ring and the filter.
Replace, if necessary.
1
41736
41751
41753
41759
41787