BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 251

Remove the steering shaft and thrust washer. It
may be necessary to tap the steering shaft out
using a wood dowel and mallet.
Pry out upper and lower steering shaft seals and
discard. Remove the upper and lower steering
shaft bushings.
Remove the tilt tube. Refer to TILT TUBE on
p. 240.
Remove the two tilt tube washers.
Remove the anode.
1. Anode
Remove the swivel bracket. Inspect and, if neces-
30735
sary, replace the tilt tube bushings.
1. Tilt tube bushing
30765 / 30764
Remove the trim sender unit from the port stern
bracket and pull its wires through the braided
tube.
30763
MIDSECTION
STERN BRACKET
1
30762
1
30761
11
30760
249