BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 215

Table of Contents

Install rod cap screws finger tight (NO MORE than

6 in. lbs. (1 N·m) maximum).

Be sure alignment dot on rod cap

matches dot on rod and that both dots face fly-

1. Alignment dots

Tightening rod cap screws without

Alignment Fixture, P/N 396749, or using an

incorrect procedure could cause permanent

damage to the connecting rod and crankshaft.

To maintain accurate torque values, keep

torque wrench extension length to a minimum.

Install Rod Cap Alignment Fixture, P/N 396749,

before tightening rod cap screws. Align the flat

marked "SET" on the rod adjustment stop with the

arrow on the frame. Position stop at the center

setting (one line showing). Rotate adjustment

knob 180° to lock in position.

1. Center position, one line showing

Secure restraining jaw "C" and forcing jaw "D" to

Restraining Jaw "C"

Forcing Jaw "D"

POWERHEAD ASSEMBLY

Chapters

Table of Contents