BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 282

GEARCASE – STANDARD ROTATION
GEARCASE DISASSEMBLY
With driveshaft bearing housing and screws in
place, insert Lower Driveshaft Spline Tool,
P/N 5007052, into lower driveshaft.
1
1. Lower Driveshaft Spline Tool
Insert Lower Driveshaft Wrench, P/N 352877,
through Lower Driveshaft Spline Tool and lower
driveshaft. Seat hex tip of wrench in head of pin-
ion screw.
1. Wrench, hex tip
IMPORTANT:
Make
Wrench is fully seated in head of pinion screw.
Use a long 3/4 in. combination wrench to hold
lower Driveshaft Spline Tool and a 1/2" drive
wrench to turn the Lower Driveshaft Wrench in a
280
005407
005408
sure Lower Driveshaft
counterclockwise direction. Loosen screw com-
pletely
Remove the four driveshaft bearing housing
screws and then the bearing housing.
1
1
1. Driveshaft bearing housing
Remove shims, thrust washer, and thrust bearing
with the lower driveshaft.
1. Shims
2. Thrust bearing
3. Thrust washer
005409
005426
1
2
3
005410