BRP EVINRUDE E-TEC 115 HP 2011 Service Manual page 23

Use an I-Command Ignition and Trim Harness to
connect the outboard to the key switch and trim/tilt
control. Seal unused SystemCheck connector
with 6-Pin Connector Seal, P/N 586076.
1
1. CANbus Ignition connector
2. Trim/Tilt connector
3. SystemCheck connector (with seal)
If connecting to an existing I-Command Classic
network, connect the purple wires between the I-
Command Ignition and Trim Harness and the I-
Command Engine Interface Cable. This connec-
tion supplies power to the network when the key
switch is on. I-Command Digital networks do not
use this connection.
1. CANbus power supply connector
Route the harnesses around the starboard side of
the powerhead along the same path as the battery
cables.
OUTBOARD RIGGING CONNECTIONS
Secure all cables with tie-straps.
2
3
1. Anchor points
For an I-Command oil level display, an accessory
CANbus oil level sender must be installed in the
005266
oil tank. Connect the sender to the I-Command
network. Refer to the I-Command Digital Net-
work Guide.
Use Evinrude Diagnostics software to adjust net-
work settings in the EMM. From the Settings
screen, select Engine Options.
1
005269
Engine Options Screen
ROUTINE SERVICE
1
005270
008013
21
2