Valid For Command: Add, Change, Audit, Sync, Show - Cisco BTS 10200 Softswitch Manual

Chapter 2 Routing
POLICY_TYPE1
POLICY_TYPE10
OL-8001-10
Description: Foreign key: Policy-type
n
plus the policy-id
n
to the Policy Profile table. Points to the next policy type table to be used in
the sequence. Policy routing continues until policy-type=route or policy-nxx
is reached. All policy-types except route point to the Policy-$type table
where $type = odr | tod | percent | prefix | oli | pop | nxx. If policy-type =
route, the Route table is used for routing. The policy-id indexes the Policy or
Route table, whatever the case may be.
Examples:
If policy-type=tod, then the Policy-tod table is indexed with policy-id.
If policy-type=route, then Route table is indexed with policy-id.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit Code based routing.
CTYPE—Call Type based routing.
NXX—Use translated DN.
ODR—Origin Dependent Routing.
OLI—Originating line information.
PERCENT—Percentage based routing
POP—Point of presence.
PREFIX—Prefix-based routing.
REGION—Region-based routing.
ROUTE—Go to Route table.
TOD—Time-of-day routing.

Valid for Command: add, change, audit, sync, show

Mandatory: add
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: See policy-type1.
VARCHAR(7): 1-7 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Policy Based Flexible Routing
2-89