Cisco BTS 10200 Softswitch Manual page 95

Chapter 1 Digit Translations
Syntax Description ALT_ROUTE_ON_
CONG
ANI_BASED_
ROUTING
ANI_DIGMAN_ID
ANI_SCREENING
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: Specifies whether to use an alternate route when there is traffic
congestion.
CHAR(1): Y/N (Default = N).
Y—SKIP
N—BLOCK
Valid for Command: add, change, audit, sync, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Used when there are multiple subscribers homing on the same
trunk group. The ANI is used to determine the subscriber ID associated with
the call.
CHAR(1): Y/N (Default = N).
Y—Determine subscriber ID based on the ANI.
N—Use normal routing.
Valid for Command: add, change, audit, sync, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Foreign key: Digman Profile table. ANI (calling party number)
digit manipulation ID.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, audit, change, show
Possible Value: [1_16]
Parser: TextParser
Description: Specifies whether to screen the call against the ANI if set.
CHAR(1): Y/N (Default = N).
N—Perform normal routing.
Y—Determine the subscriber ID based on the ANI Screening table.
Valid for Command: add, change, audit, sync, show
Mandatory: add
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-79