International Wz1 (Intl_Wz1) Preferred Carrier Routing - Cisco BTS 10200 Softswitch Manual

Routing Types
Routing Number Routing for Called Party Number With Ported Nature of Number and Routing Number + Directory Number
An incoming trunk call is received with the Called Party Number containing the NOA associated with a
ported DN. There will be a matching entry in the NOA Route entry and a destination ID. That is, the
NOA Route entry with NOA of PORTED-NUMBER-WITH-RN (which is the value associated with
NOA ITU Q.769 value 8). This destination ID may then contain a dial-plan ID for a dial plan for RN
routing.
Local Number Portability Query Returns Routing Number for Ported Directory Number
When the Cisco BTS 10200 Softswitch performs an LNP query and finds an RN for a ported number
that is not in this switch, the call is routed onward. The dial-plan-profile associated with the originating
subscriber or trunk has NOA-ROUTING=Y, and the NOA Route Profile ID of the NOA Route that
contains a destination ID. Note that for a country such as France, which uses an RN prefix but with a
standard NOA (3, National), after an LNP query on the Cisco BTS 10200 Softswitch, digit manipulation
must be used to replace the NOA value ported- number with RN value to national.

International WZ1 (INTL_WZ1) Preferred Carrier Routing

This section describes the preferred carrier (PIC) routing for an international world zone 1 call. In the
past releases, the BTS 10200 supported preferred carrier (PIC) routing based on the routing application
defined for the North America PSTN environment.
behavior in prior releases of the BTS 10200.
Table 2-4
CALL TYPE
CALLTYPE_INTERLATA
CALLTYPE_INTL_WZ1
CALLTYPE_TOLL
CALLTYPE_INTL
Because different customers have different needs regarding the routing for INTL_WZ1 calls, the
flexibility of preferred carrier routing for INTL_WZ1 calls has been enhanced as shown in
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
2-26
General Preferred Routing
PIC
PIC1
PIC2
PIC3/PIC1
Table 2-4 lists the general preferred carrier routing
Description
Uses SUBSCRIBER.PIC1 to route the call. If PIC1 is
not provisioned then route the call to POP.LECOSS.
If POP.ITP is set to Y then uses SUBSCRIBER.PIC2 to
route the call. Otherwise, route the call according to the
provisioning defined in DIAL_PLAN.
Uses SUBSCRIBER.PIC3 to route the call if PIC3 is
provisioned. If PIC3 is not provisioned then use
SUBSCRIBER.PIC1 to route the call. If neither PIC1
nor PIC3 is provisioned then route the call to
POP.LECOSS.
Chapter 2 Routing
Table 2-5.
OL-8001-10