Cisco BTS 10200 Softswitch Manual page 18

Introduction
Routing—The Routing is performed in the analyzed info point in call (PIC). The Destination Table
and/or Route Table can be used to specify digit manipulation of ANI, DNIS or both. The out-pulsing
number can be normalized using the destination table. In addition, if special manipulation is required
based on the route selected, then that can be specified with each Trunk Group within a route.
If the Called Party Number terminates within the Cisco BTS 10200 Softswitch, and the subscriber
number points to a Trunk Group, then digit manipulation rules for ANI, DNIS, or both can be specified
in the Trunk Group Table.
If the call is an interLATA call, or requires Carrier Routing, the ANI/DNIS digit manipulation
identification (IDs) specified in the Destination table are ignored and carrier based routing is performed.
Figure 1-2
includes the ANI/DNIS digital manipulation functions.
Figure 1-2 Dial Plan Provisioning Relationships
digman-id
Digman Profile
table
ani-digman-id
dnis-digman-id
ani-digman-id
dnis-digman-id
ani-digman-id
dnis-digman-id
ani-digman-id
dnis-digman-id
tgn-id (1 through 10)
ani-digman-id
dnis-digman-id
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-2
illustrates the provisioning relationships for Cisco BTS 10200 Softswitch dial plans, which
match-string
replace-strng
Digman table(s)
match-noa
1 through 20 (max)
replace-noa
nat-dial-plan-id
Dial Plan Profile
table
dest-id
call-type
carrier-id
Destination
dial-plan-id
table
route-id
route-guide-id
call-agent-id
carrier-id
cause-code-map-id
Trunk Group
dial-plan-id
table
main-sub-id
pop-id
qos-id
sp-id
alt-route-id
Route table
call-agent-id (1 through 10)
dialed-digits
noa
del-digits
Dial Plan table
pfx-digits
intl-dial-plan-id
intl-dial-plan-id
Intl Dial Plan
Profile table
Chapter 1 Digit Translations
Intl Dial Plan
table
dest-id
OL-8001-10