Cisco BTS 10200 Softswitch Manual page 143

Chapter 2 Routing
Table 2-5
CALL TYPE
CALLTYPE_INTERLATA
CALLTYPE_INTL_WZ1
CALLTYPE_TOLL
CALLTYPE_INTL
There is no change to CALLTYPE_INTERLLATA, CALLTYPE_TOLL, and CALLTYPE_INTL. The
CALLTYPE_INTL_WZ1 has two different flavors of preferred carrier routing controlled by the
CA-CONFIG:INTL_WZ1_PIC3 flag.
For operator assisted calls, there are minor differences between PIC2 and PIC1/PIC3. A call associated
with PIC1 or PIC3 is routed to the PIC1/PIC3 carrier if the SUB_PROFILE.EA_USE_PIC1 is set to Y,
otherwise the call is routed to POP.LECOSS. A associated with PIC2 is routed to the PIC2 carrier.
When a call is routed to any PICx carrier but the specific carrier does not support it
Note
(CARRIER.OP-SERVICES=N), the will be rerouted to POP.LECOSS.
Casual calls are routed to PICx carrier according to the call type if the specified carrier supports casual
calls (CARRIER.CASUAL=N), otherwise the call is blocked.
OL-8001-10
Enhanced Preferred Routing
PIC
PIC1
PIC1
PIC3/PIC1
PIC2
PIC3/PIC1
Description
Uses SUBSCRIBER.PIC1 to route the call. If PIC1 is
not provisioned then route the call to POP.LECOSS.
Filter: CARRIER: INTER
CA-CONFIG:INTL_WZ1_USE_PIC3 = N
Uses SUBSCRIBER.PIC1 to route the call. If PIC1 is
not provisioned then route the call to POP.LECOSS.
Filter: CARRIER: INTER or CARRIER: INTL
(Allow call goes through if either one set to Y)
CA-CONFIG:INTL_WZ1_USE_PIC3 = Y
Uses SUBSCRIBER.PIC3 to route the call if PIC3 is
provisioned. If PIC3 is not provisioned then use
SUBSCRIBER.PIC1 to route the call. If neither PIC1
nor PIC3 is provisioned then route the call to
POP.LECOSS.
Filter: CARRIER: INTER or CARRIER: INTL
(Allow call goes through if either one set to Y)
If POP.ITP is set to Y then uses SUBSCRIBER.PIC2 to
route the call. Otherwise, route the call according to the
provisioning defined in DIAL_PLAN.
Filter: CARRIER: INTRA
Uses SUBSCRIBER.PIC3 to route the call if PIC3 is
provisioned. If PIC3 is not provisioned then use
SUBSCRIBER.PIC1 to route the call. If neither PIC1
nor PIC3 is provisioned then route the call to
POP.LECOSS.
Filter: CARRIER: INTL
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Routing Types
2-27