Cisco BTS 10200 Softswitch Manual page 189

Chapter 2 Routing
DEFAULT_POLICY_
TYPE
DISPLAY
END_RANGE1
OL-8001-10
Description: Points to the default policy type to use if the next route is not
found in the Policy table. Policy routing continues until policy-type=route or
policy-nxx is reached. All policy types except Route point to the Policy Type
table where type = ctype| odr | tod | percent | prefix | oli | pop | nxx. If
policy-type = route, the Route table is used for routing. The policy-id is used
to index to the Policy or Route table. Some examples are: If policy-type=tod,
then the Policy TOD table is indexed with policy-id. If policy-type=route,
then the Route table is indexed with policy-id.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit code based routing.
CTYPE—Call type based routing.
NXX—Use translated DN.
ODR—Origin dependent routing.
OLI—Originating line information.
POP—Point of presence.
PERCENT—Percentage based routing.
PREFIX—Prefix-based Routing.
REGION—Region based Routing
ROUTE—Go to Route table.
TOD—Time of day routing.
Valid for Command: add, change, audit, sync, show
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: Specifies what token information to display on the screen. Valid
only for the show command.
VARCHAR(1024): 1-1024 (Default = all tokens are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Description: Defines the end of the percent range (beginning and ending
percents) for the first destination.
SMALLINT: 1-100.
Valid for Command: add, change, audit, sync, show
Mandatory: add
Possible Value: [1_100]
Parser: DecimalParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Policy Based Flexible Routing
2-73