Cisco BTS 10200 Softswitch Manual page 72

Automatic Number Identification/Dialed Number Identification Service Manipulation
ACQ_LNP_QUERY
ANI_DIGMAN_ID
ANNC_ID
AUTO_REFRESH
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-56
Description: Specifies whether an LNP Query is required. Applies only if the
all-call-query token is set to Y and lnp-db-type=RN in the LNP Profile table.
VARCHAR(32): 1-32 ASCII characters. Permitted values are:
NA (Default)—Not applicable.
ACQ-BASED-ON-CALL-TYPE—Applies only if lnp-db-type in the LNP
Profile table is ACQ. Perform an LNP Query based on definition in the Call
Type Profile table. If the call type is not found in the Call Type Profile table,
then an LNP Query is not performed.
PERFORM-LNP-QUERY—Used when a call type-specific query is not
required but LNP criteria is defined based on the destination ID. An LNP
query is performed if the all-call-query flag in the LNP Profile table is set to
Y.
NO-LNP-QUERY—Do not perform an LNP query on this destination.
Valid for Command: add, change, audit, sync, show
Default Value: NA
Possible Value: NA, ACQ_BASED_ON_CALL_TYPE,
PERFORM_LNP_QUERY, NO_LNP_QUERY
Parser: TextNoCaseParser
Description: Foreign key: Digman Profile table. ANI (calling party number)
digit manipulation ID.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, audit, change, show
Possible Value: [1_16]
Parser: TextParser
Description: Mandatory only if route-type=annc or pre-completion-annc=y.
Foreign key: Announcement table. Announcement ID.
SMALLINT: 1-1000.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_1000]
Parser: DecimalParser
Description: Specifies whether to display cached data on the screen. Valid
only for the show command.
CHAR(1): Y/N (Default = Y).
Y—Queries the database for the most current data.
N—Queries the database for the most current data only if the cached data is
unavailable.
Valid for Command: show
Default Value: Y
Possible Value: Y, N
Parser: BooleanParser
Chapter 1 Digit Translations
OL-8001-10