Cisco BTS 10200 Softswitch Manual page 108

Automatic Number Identification/Dialed Number Identification Service Manipulation
TRAFFIC_TYPE
TRUNK_SUB_GRP
VOICE_INFO_
TRANSFER_CAP
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-92
Description: Specifies the type of traffic carried over this trunk group. It is
required for incoming and bothway trunk groups. If it is not specified, the
Call Agent defaults to local.
VARCHAR(8): 1-8 ASCII characters. Permitted values are:
LOCAL (Default)—Local incoming trunk group.
PBX—Not used. Incoming PBX trunk group (for ISDN and CAS), DAL, and
so forth.
TANDEM—Incoming local/tandem trunk group. Calls are allowed to a
tandem trunk.
USER—Cisco BTS 10200 acts as a user side (PBX) toward the network.
Valid for Command: add, change, audit, sync, show
Default Value: LOCAL
Possible Value: LOCAL, TANDEM, PBX, USER
Parser: TextParser
Description: Unique key: softsw-tsap-addr+trunk-sub-grp. Identifies a
specific trunk group when multiple trunk groups exist between a Cisco BTS
10200 Softswitch and another softswitch.
VARCHAR(64): 1-64 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_64]
Parser: TextParser
Description: Information sent in the forward direction indicating the type of
transmission medium required for the connection.
VARCHAR(16): 1-16 ASCII characters (Default = AUTO). Permitted values
are:
AUTO—Same as configured or received for the incoming leg/
SPEECH—If voice call, override with Speech.
3POINT1KHZ-AUDIO—If voice call, override with 3.1 KHz audio.
Valid for Command: add, show, change, audit, sync
Default Value: AUTO
Possible Value: AUTO, SPEECH, 3POINT1KHZ_AUDIO
Parser: TextNoCaseParser
Chapter 1 Digit Translations
OL-8001-10