Cisco BTS 10200 Softswitch Manual page 157

Chapter 2 Routing
Syntax Description AUTO_REFRESH
DEFAULT_POLICY_
ID
DEFAULT_POLICY_
TYPE
OL-8001-10
Description: Specifies whether to display cached data on the screen. Valid
only for the show command.
CHAR(1): Y/N (Default = Y).
Y—Queries the database for the most current data.
N—Queries the database for the most current data only if the cached data is
unavailable.
Valid for Command: show
Default Value: Y
Possible Value: Y, N
Parser: BooleanParser
Description: Use default policy ID when there is no match with the above
schedule. Assigned by service provider.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Points to the default policy type to use if the next route is not
found in the Policy table. Policy routing continues until policy-type=route or
policy-nxx is reached. All policy types except Route point to the Policy Type
table where type = ctype| odr | tod | percent | prefix | oli | pop | nxx. If
policy-type = route, the Route table is used for routing. The policy-id is used
to index to the Policy or Route table. Some examples are: If policy-type=tod,
then the Policy TOD table is indexed with policy-id. If policy-type=route,
then the Route table is indexed with policy-id.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit code based routing.
CTYPE—Call type based routing.
NXX—Use translated DN.
ODR—Origin dependent routing.
OLI—Originating line information.
POP—Point of presence.
PERCENT—Percentage based routing.
PREFIX—Prefix-based Routing.
REGION—Region based Routing
ROUTE—Go to Route table.
TOD—Time of day routing.
Valid for Command (is): audit, sync, show
Valid for Command (was): add, change, audit, sync, show
Possible Value: ODR, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Policy Based Flexible Routing
2-41