Cisco BTS 10200 Softswitch Manual page 94

Automatic Number Identification/Dialed Number Identification Service Manipulation
Command Types add, audit, change, control, delete, help, show, status, sync
Sync is a restricted command and is intended for repairing data only. Improper use may corrupt database
Caution
and disrupt call processing. Use with caution.
Examples
show trunk-grp id=101;
add trunk-grp id=101; call-agent-id=CA146; tg-type=ss7; dial-plan-id=tg-dp;
dpc=101-55-103; tg-profile-id=SS71; call-ctrl-route-id=ccr1;
change trunk-grp id=101; cost=200;
delete trunk-grp id=101;
Usage Guidelines Primary Key Token(s): ID
Foreign Key Token(s): call-agent-id, ani-digman-id, call-control-route-id, carrier-id,
cause-code-map-id, dial-plan-id, dnis-digman-id, isdn-dchan, h323-gw-id, main-sub-id, pop-id, qos-id,
sp-id, ani-screening-profile-id
Add Rules:
•
•
Change Rules:
•
•
Delete Rules:
•
•
•
Upgrade Impact:
•
•
•
•
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-78
ID exists in the carrier table; id exists in the subscriber table.
DIAL-PLAN-ID is required except if tg-typ=ANNC or if main-sub-id is not equal to NULL.
Ensure that the id exists in the Subscriber table if entered; ensure the id exists in the Media Gateway
table if entered.
The DPC field cannot be changed.
ID cannot exist in any subscriber::term-id; ID cannot exist in any trunk::term-id.
ID cannot exist in any mlhg-terminal::term-id.
Trunk group status must be OOS.
IF TG-TYPE=ISDN, Name the ISDN-DCHAN-ID as TGN# ( e.g. 9009991)
STATUS_MONITORING is moved to SIP_ELEMENT table
Set CUT_THRU_BEFORE_ANSWER (moved from ISDN-TG-PROFILE) to N.
Pre-check on 4.5 before upgrade, if POP_ID is null, provision a valid POP_ID at 4.5 side before
upgrade.
Chapter 1 Digit Translations
OL-8001-10