Cisco BTS 10200 Softswitch Manual page 102

Automatic Number Identification/Dialed Number Identification Service Manipulation
ORDER
PERFORM_LNP_
QUERY
PFX_DIGITS
PLATFORM_STATE
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-86
Description: Specifies whether to display data on the screen in a sorted order.
Valid only for the show command.
VARCHAR(1024): 1-1024 (Default = all rows are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Description: Specifies whether to perform an LNP query. This token applies
only to incoming calls (for ITU local LNP, when the LNP Profile lnp-db-type
is RN).
CHAR(1): Y/N (Default = N).
Y—Perform an LNP Query if required based on the LNP Profile table and
the acq-lnp-query token in the Destination table. This applies to both LNP
Types: ACQ and QOR. Set this token to Y when the remote switch is not
LNP-capable.
N—An LNP query is not required as originating switch is LNP-capable or
LNP is not required.
Valid for Command: add, change, audit, sync, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Specifies what digits to prefix. Digits are prefixed after the
specified number of digits are deleted.
VARCHAR(10): 1-10 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [0_10]
Parser: GenericDNParser
Description: State of an active or standby system shared memory database;
use to audit an active or standby system shared memory database. Valid for
the audit database and audit table name commands.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
ACTIVE (Default)—System is active (currently running).
STANDBY—System is in standby mode.
EMS—Audits the active EMS to the standby EMS.
Valid for Command: sync, audit
Default Value: ACTIVE
Possible Value: ACTIVE, STANDBY
Parser: TextParser
Chapter 1 Digit Translations
OL-8001-10