Cisco BTS 10200 Softswitch Manual page 257

Chapter 4 Command Line Interface Routing
Check the POP table for a defined LECOSS. If a LECOSS is defined in the POP table, the Cisco BTS
Step 4
10200 Softswitch will route the call via the LECOSS. If a LECOSS is not defined in the POP table, the
Cisco BTS 10200 Softswitch will block the call.
Example:
POP LEC-OSS
Step 5 Check the POP table for a configured ITP. If an ITP is configured, proceed to Step 6. If an ITP is not
configured return to Step 4.
Example:
POP ITP = Y
Step 6 Check the subscriber table for a specified PIC. If a PIC is specified, proceed to Step 7. If a PIC is not
specified, the Cisco BTS 10200 Softswitch will route the call to the announcement server. Additionally,
if a PIC is not specified in the subscriber table, the Cisco BTS 10200 Softswitch will check the POP table
for a specified PIC. If a PIC is specified in the POP table, the Cisco BTS 10200 Softswitch will block
the call. If a PIC is not specified in the POP table, return to Step 4.
Examples:
Subscriber Test1
POP LEC-OSS
Check the intra carrier table for the specified PIC. If the specified PIC is included in the intra carrier
Step 7
table, the Cisco BTS 10200 Softswitch will select the call route and route the call based on the PIC
information. If the specified PIC is not included in the intra carrier table, return to Step 4.
Example:
Carrier Intra = Y
OL-8001-10
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Call Types
4-17