Cisco BTS 10200 Softswitch Manual page 75

Chapter 1 Digit Translations
GAP_ROUTING
INTRA_STATE
LIMIT
MASTER
ORDER
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: If set, and a generic address parameter is present, check if the
called number in the GAP parameter is a Call Agent PBX subscriber, based
on the Office Code table.
CHAR(1): Y/N (Default = N).
Y—Check called number in the GAP.
N—Do not check called number in the GAP.
Valid for Command: add, change, audit, sync, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Specifies if dialed digits are for an intrastate (toll) destination.
CHAR(1): Y/N (Default = Y).
Y—Intrastate
N—Interstate
Valid for Command: add, change, audit, sync, show
Default Value: Y
Possible Value: Y, N
Parser: BooleanParser
Description: Specifies the number of rows to display on the screen. Valid
only for the show command.
INTEGER: 1-100000000 (Default = 100000000).
Valid for Command: show
Default Value: 100000000
Possible Value: [1_100000000]
Parser: DecimalParser
Valid for Command: sync
Mandatory: sync
Possible Value: [1_10]
Parser: TextParser
Description: Specifies whether to display data on the screen in a sorted order.
Valid only for the show command.
VARCHAR(1024): 1-1024 (Default = all rows are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-59