Cisco BTS 10200 Softswitch Manual page 97

Chapter 1 Digit Translations
CAUSE_CODE_MAP_
ID
CLLI
COST
DEFAULT_CHG
DEL_DIGITS
DESCRIPTION
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: Foreign key: Cause Code Map table. The cause code map ID.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Common Language Location Identifier for the remote switch.
CHAR(11): Eleven ASCII characters.
Valid for Command: add, audit, change, show
Possible Value: [11_11]
Parser: TextParser
Description: Relative cost value; used if TG selection is based on least cost
routing (LCR).
SMALLINT: 0-999.
Valid for Command: add, change, audit, sync, show
Possible Value: [0_999]
Parser: DecimalParser
Description: Default charge number.
VARCHAR(16): 1-16 numeric digits.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Specifies the number of digits to delete.
SMALLINT: 0-14 numeric characters. (Default = 0).
Valid for Command: add, change, audit, sync, show
Default Value: 0
Possible Value: [0_14]
Parser: DecimalParser
Description: Described by the service provider.
VARCHAR(64): 1-64 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_64]
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-81