Cisco BTS 10200 Softswitch Manual page 56

Cisco systems softswitch dial plan guide
Hide thumbs Also See for BTS 10200 Softswitch:
Table of Contents

Advertisement

Automatic Number Identification/Dialed Number Identification Service Manipulation
NAT_DIAL_PLAN_ID Description: Foreign key: Dial Plan table. National dial plan ID to use to
NOA_BASED_
ROUTING
NOA_ROUTE_
PROFILE_ID
ORDER
OVERDECADIC_
DIGITS_SUPP
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-40
retranslate dialed digits. This token is used only if the dial plan ID is
different from the dial plan profile ID.
VARCHAR(16): 1-16 ASCII characters (Default = dial-plan-profile-id).
Valid for Command: add, audit, change, show
Possible Value: [1_16]
Parser: TextParser
Description: Specifies whether Nature of Address based routing is required.
CHAR(1): Y/N (Default = N)
Valid for Command: add, audit, change, show, sync
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Mandatory if noa-based-routing=Y. Foreign key: NOA Route
Profile table. Specifies the NOA-specific route id to use for routing. When
NOA-based-routing is specified, the NOA is used to index the NOA Route
table. If a NOA-specified record is found, processing continues based on the
Destination ID specified in the NOA Route table. If no record is found, then
the Called Number is translated in the current Dial Plan.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, audit, change, show, sync
Possible Value: [1_16]
Parser: TextParser
Description: Specifies whether to display data on the screen in a sorted order.
Valid only for the show command.
VARCHAR(1024): 1-1024 (Default = all rows are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Description: Controls provisioning of overdecadic digits in a dial plan. This
token can only be set to Y if the nanp-dial-plan token is set to N.
CHAR(1): Y/N (Default = N).
Valid for Command: add, audit, change, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Chapter 1
Digit Translations
OL-8001-10

Advertisement

Table of Contents
loading

Table of Contents