Cisco BTS 10200 Softswitch Manual page 182

Policy Based Flexible Routing
POLICY_TYPE
START_ROW
TARGET
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
2-66
Description: Points to the next policy type table to use in the sequence.
Policy routing continues until policy-type=route or policy-nxx is reached.
All policy-types except route point to the Policy-$type table where $type =
odr | tod | percent | prefix | oli | pop | nxx. If policy-type = route, the Route
table is used for routing. The policy-id indexes the Policy or Route table,
whatever the case may be.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit Code based routing
CTYPE—Call Type based routing
NXX—Use translated DN.
ODR—Origin Dependent Routing.
OLI—Originating line information.
PERCENT—Percentage based routing
POP—Point of presence.
PREFIX—Prefix-based routing.
REGION—Region-based routing.
ROUTE—Go to Route table.
TOD—Time-of-day routing.
Valid for Command: add, change, audit, sync, show
Mandatory: add
Possible Value: TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: Specifies to begin displaying data on the screen at a specific
row. Valid only for the show command.
INTEGER: 1-100000000 (Default = 1).
Valid for Command: show
Default Value: 1
Possible Value: [1_100000000]
Parser: DecimalParser
Description: Specifies the network element to receive the request.
VARCHAR(5): 1-5 ASCII characters. Permitted values are:
CA—Network identifier of a Call Agent.
FSPTC (POTS/Tandem/Centrex Feature Server)—Network identifier of a
specific Feature Server.
FSAIN (AIN Feature Server)—Network identifier of AIN Feature Servers.
Valid for Command: sync
Mandatory: sync
Possible Value: [1_10]
Parser: TextParser
Chapter 2 Routing
OL-8001-10