Cisco BTS 10200 Softswitch Manual page 105

Chapter 1 Digit Translations
SEND_RDN_AS_CPN
SIGNAL_PORTED_
NUMBER
SOFTSW_TSAP_
ADDR
SOURCE
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: Use when a call is forwarded and call routing is to the PSTN
where Calling Party Number Screening is performed. If redirecting number
information is available, the Cisco BTS 10200 Softswitch overwrites the
calling party number with RDN. Otherwise, if Original Called number
information is available, the Cisco BTS 10200 Softswitch overwrites the
calling party number with the OCN.
CHAR(1): Y/N (Default = N).
Valid for Command: add, change, audit, sync, show
Mandatory: add
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Used for local number portability (LNP) when the next switch
does not support LNP. The local routing number (LRN) from the called party
number is removed and the called party number parameter is filled with the
called party number from GAP. The translated bit (M-bit) is also reset.
CHAR(1): Y/N (Default = N).
Y—Send IAM without GAP.
N—Send GAP.
Valid for Command: add, change, audit, sync, show
Default Value: N
Possible Value: Y, N
Parser: BooleanParser
Description: Mandatory if tg-type=softsw. Unique key between
softsw-tsap-addr + trunk-sub-grp. TSAP address of the softswitch if
tg-type=softsw. Use different ports if multiple trunk groups to the same
softswitch are supported.
VARCHAR(64): 1-64 ASCII characters. Domain names cannot begin with a
number.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_64]
Parser: DomainParser
Description: Source of the infraction—name in the Users table. Source is
actually the username. If you enter source without a start-time or end-time,
all infractions are shown.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: status
Mandatory: status
Default Value: AGENT
Possible Value: EMS, AGENT
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-89