Cisco BTS 10200 Softswitch Manual page 193

Chapter 2 Routing
POLICY_TYPE1
POLICY_TYPE2
POLICY_TYPE3
OL-8001-10
Description: Points to the next policy type table to be used in the sequence.
Policy routing continues until policy-type=route or Policy-nxx is reached.
All policy-types except route point to the Policy-$type table where $type =
odr | tod | percent | prefix | oli | pop | nxx. If policy-type = route, the Route
table is used for routing. The policy-id indexes the Policy or Route table,
whatever the case may be.
Examples:
If policy-type=tod, then the policy-tod table is indexed with policy-id.
If policy-type=route, then the route table is indexed with policy-id.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit Code based routing.
CTYPE—Call Type based routing.
NXX—Use translated DN.
ODR—Origin Dependent Routing.
OLI—Originating line information.
PERCENT—Percentage based routing
POP—Point of presence.
PREFIX—Prefix-based routing.
REGION—Region-based routing.
ROUTE—Go to Route table.
TOD—Time-of-day routing.
Valid for Command: add, change, audit, sync, show
Mandatory: add
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: See policy-type1.
VARCHAR(7): 1-7 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: See policy-type1.
VARCHAR(7): 1-7 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: ODR, TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Policy Based Flexible Routing
2-77