Cisco BTS 10200 Softswitch Manual page 76

Automatic Number Identification/Dialed Number Identification Service Manipulation
PLATFORM_STATE
ROUTE_GUIDE_ID
ROUTE_ID
ROUTE_TYPE
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-60
Description: State of an active or standby system shared memory database;
use to audit an active or standby system shared memory database. Valid for
the audit database and audit table name commands.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
ACTIVE (Default)—System is active (currently running).
STANDBY—System is in standby mode.
EMS—Audits the active EMS to the standby EMS.
Valid for Command: sync, audit
Default Value: ACTIVE
Possible Value: ACTIVE, STANDBY
Parser: TextParser
Description: Mandatory only if route-type=route. Foreign key: Route Guide
table. Valid route guide ID from the Route Guide table.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Mandatory only if route-type=route. Foreign key: Route table.
Valid Route ID from the Route table.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Routing type.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
ANNC—Use annc-id to terminate call.
CARRIER—For SAC calls. The call is routed based on the routing specified
in the Carrier table.
DP—Use dial-plan-id to retranslate based on the new dial plan ID.
NONE—No route required. Use for NAS application.
RID—Use route-id for routing.
ROUTE—Use route-guide-id for routing.
SCRIPT—(Not supported) Use a scripting package to terminate a call.
SUB—Subscriber termination. Use office code index and last four digits of
the DN to find the subscriber.
Valid for Command: add, change, audit, sync, show
Mandatory: add
Possible Value: SUB, CARRIER, ROUTE, ANNC, RID, DP, NONE,
SCRIPT
Parser: TextNoCaseParser
Chapter 1 Digit Translations
OL-8001-10