Cisco BTS 10200 Softswitch Manual page 158

Policy Based Flexible Routing
DISPLAY
DOY1
DOY1_POLICY_ID
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
2-42
Description: Specifies what token information to display on the screen. Valid
only for the show command.
VARCHAR(1024): 1-1024 (Default = all tokens are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Description: Month and day (day of year provisioning).
CHAR(5): 5 characters in the format mm-dd.
Valid for Command: add, change, audit, sync, show
Possible Value: [5_5]
Parser: DateParser
Description: ID of the Policy or Route table that matches the policy type.
Indexes the ID to the type. Points to the next policy type table to be used in
the sequence. Policy routing continues until policy-type=route or policy-nxx
is reached. All policy-types except route point to the policy-$type table
where $type = odr | tod | percent | prefix | oli | pop | nxx. If policy-type =
route, the route table is used for routing. The policy-id indexes the Policy or
Route table, whatever the case may be.
Examples:
If policy-type=tod, then policy-tod table is indexed with policy-id.
If policy-type=route, then Route table is indexed with policy-id.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Chapter 2 Routing
OL-8001-10