Cisco BTS 10200 Softswitch Manual page 98

Automatic Number Identification/Dialed Number Identification Service Manipulation
DIAL_PLAN_ID
DIRECTION
DISPLAY
DNIS_DIGMAN_ID
DPC
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-82
Description: Foreign key: Dial Plan table. Specifies which dial plan ID to
use. For trunk groups with a main subscriber id (CAS, ISDN), the Call Agent
uses the dial-plan-id assigned to the trunk group (if available), else it uses
the dial-plan-id assigned to the subscriber profile.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Direction of the trunk group. Can be incoming only, outgoing
only, or both incoming and outgoing. If bothway, the glare parameter is
required.
VARCHAR(4): 1-4 ASCII characters. Permitted values are:
BOTH (Default)—Bothway trunk group (used for both incoming and
outgoing calls).
OUT—Used for outgoing calls only.
IN—Used for incoming calls only.
Valid for Command: add, change, audit, sync, show
Default Value: BOTH
Possible Value: BOTH, OUT, IN
Parser: TextParser
Description: Specifies what token information to display on the screen. Valid
only for the show command.
VARCHAR(1024): 1-1024 (Default = all tokens are displayed). Permitted
values are any valid token that can be shown for this command. Multiple
tokens can be entered by separating with a comma.
Valid for Command: show
Possible Value: [1_1024]
Parser: TextParser
Description: Foreign key: Digman Profile table. DNIS (called party number)
digit manipulation ID.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, audit, change, show
Possible Value: [1_16]
Parser: TextParser
Description: Not provisionable. Mandatory if tg-type=SS7. Destination
Point Code if SS7. The DPC is automatically provisioned from the
call-ctrl-route-id.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: audit, sync, show
Possible Value: [0_16]
Parser: PointCodeParser
Chapter 1 Digit Translations
OL-8001-10