System Configuration - GE Healthcare Brivo XR118 Service Manual

GE H
EALTHCARE
D 5461425-8EN, R
IRECTION
Section 9.0

System Configuration

9.1 When to Perform System Configuration
Potential for Data Loss:
1.) Always create an up-to-date backup of your system data following product installation or
2.) Upon exiting the Service User Interface (SUIF), for Configuration and Calibration information
9.1.1 During System Installation
Your system is delivered to you configured to default values. You should configure your system to
the values that are appropriate for your particular installation. The items that must be configured are
identified in
Table 12-1 System Configuration Parameters
See System Configuration Tool
Parameters
See Hardware AP Configuration
See DICOM Configuration & DICOM
Printers
See Operator Manual (OM) Installation
See Adding a Bar Code Reader
See User Accounts
9.1.2 Missing or Lost System Backups
If you perform a software install and do not restore configuration files, you must re-perform all of
configurations listed in, after it's complete. A software install resets all configuration data. If you
performed a [backup] before you began the software install, you are not required to perform the
configuration and calibrations. Simply [restore] the data saved previously.
9.1.3 Addition of Purchased Options
Installation of purchased options can only be performed by your authorized GE sales and service
representative. If you add purchased options to your system, you should update the system
configuration files immediately and create and save a new backup.
Page 74
6
EVISION
changes to configuration data.
to take effect, the system must be reset. This must be done before the system is used for
patient acquisitions.
Table 12-1.
Comments
Section 9.0 - System Configuration
B
System Configuration Parameter
Site
General
Wireless Connection
DICOM
Operator Manual
Bar Code Reader (Option)
System Login (HIPPA)
XR118 S M
RIVO ERVICE ANUAL