GE Healthcare Brivo XR118 Service Manual page 69

GE H
EALTHCARE
D 5461425-8EN, R
IRECTION
Note:
6.) Login to System
Note:
7.) Create User Accounts (Not Required if you have a System Calibration/Configuration Backup
8.) Are you performing a new system installation?
9.) Congratulations, you're finished SW OS/APP installation.
8.3.5 Detectors Switch Software Patch Installation Procedure
In order to keep 2 detectors switch time shorter than 30s, need to run below procedure after
9.9.1.2; Preference
Note: FE can find 5589170-1 Software Patch CD in the "open me first" pink box.
Note: For XR118 system with only one detector, this procedure can be ignored. For XR118 system with
two detectors, below process is mandatory.
Note: Please order 5589170-1 by spare part order process if there is no CD 5589170-1 in the pink box.
1.) Insert 5589170-1 Software Patch CD for Brivo XR118 into portable CD/DVD drive and connect
2.) Open EnggUI using command: Ctrl+Shift+F5 and then click on "Terminal" icon
3.) Perform below command step by step:
6
EVISION
Please wait this page to disappear..
vii.) Remove the software DVD from the USB DVD drive.
Username and password are case sensitive. Enter them carefully.
i.) Enter username.
Username: ******
ii.) Enter password.
Password: ******
CD/DVD).
Enter hospital user names and passwords, if they do not already exist on a system back CD/
DVD.
i.) Yes, skip to Step 9
ii.) No, proceed onto "Restore on page
- If you are installing a new system with only one detector, then perform configuration and
calibration tasks.
- If the new system is configured with more than one detector, then run
Detectors Switch Software Patch Installation
calibration tasks.
Tab..
to iServer.
Chapter 5 - - Installation & Configuration
B
RIVO
71".
Procedure., then perform configuration and
XR118 S M
ERVICE ANUAL
Section 8.3.5;
Section
Page 69