Set Igmp Lmqi - 3Com Wireless LAN Switch WX1200 Command Reference Manual

434 C 13: IGMP S
HAPTER

set igmp lmqi

C
NOOPING OMMANDS
Changes the IGMP last member query interval timer on one VLAN or all
VLANs on a wireless LAN switch.
Syntax —
set igmp lmqi tenth-seconds [vlan vlan-id]
lmqi tenth-seconds
the WX waits for a response to a group-specific query after receiving a
leave message for that group, before removing the receiver that sent
the leave message from the list of receivers for the group. If there are
no more receivers for the group, the WX switch also sends a leave
message for the group to multicast routers. You can specify a value
from 1 through 65,535.
vlan vlan-id
VLAN, the timer change applies to all VLANs.
Defaults — The default last member query interval is 10 tenths of a
second (1 second).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the last member query
interval on VLAN orange to 5 tenths of a second:
WX1200# set igmp lmqi 5 vlan orange
success: change accepted.
See Also
set igmp oqi on page 437
set igmp qi on page 439
set igmp mrouter on page 435
— Amount of time (in tenths of a second) that
— VLAN name or number. If you do not specify a