Display And Evaluation Of Diagnostic Information - Siemens SINUMERIK MC Commissioning Manual

Diagnostics

7.5 Display and evaluation of diagnostic information

7.5 Display and evaluation of diagnostic information
In the "Safety Integrated" mode, safety-relevant monitoring functions are integrated and
executed in the drive. Diagnostic information is communicated and evaluated as follows:
● The status and control information (SIC/SCC) (Page 212) of the drive are transferred
between the integrated subcomponents of the SINUMERIK MC:
– As a consequence, the motion control in the NC is also linked (Page 333) to the Safety
– Some SIC status information is also saved to NC variables (OPI) (Page 351).
● SINAMICS S120 drive messages and alarms can be displayed as follows:
– Safety messages of the drive are displayed in the SINUMERIK ONE Commissioning
– The standard alarm of a drive can also include safety-relevant diagnostic information.
– Display and acknowledgment (Page 337) of messages depend on the scope of the
324
Integrated Functions integrated in the drive, therefore avoiding unnecessary follow-on
responses in the NC.
Tool in the alarm lists.
You must activate the alarm buffer (Page 335) so that these are displayed in the
SINUMERIK ONE Commissioning Tool.
Safety Integrated Functions (Page 24) used - and the use of the safety message buffer
(Page 335).
Safety Integrated (with SINAMICS S120)
Commissioning Manual, 02/2020, A5E46305916B AB