Unpack And Inspect Media Gateways; Check Circuit Packs - Avaya S8700 Installing Manual

Unpack and Inspect Media Gateways

!
CAUTION:
Lifting the media gateway requires two people, as it may weigh as much as 130 pounds
(60 kilograms). Use caution to avoid injury.
Unpack the media gateways from the shipping material and inspect for damage.
1
2 Open and remove the front door and rear panels from the media gateway.
3 Verify the label near the circuit breaker on the power supply toward the rear of each
media gateway corresponds to the local voltage type.
!
DANGER:
If the label is different than the voltage type at the site, notify your Avaya
representative immediately for a replacement power supply. Do not, under any
circumstances, connect an incorrect power supply to a power source.

Check Circuit Packs

1 Ensure all circuit packs are fully inserted into the proper slots according to the Customer
Service Document (CSD).
Report any discrepancies in circuit pack type or quantity to your Lucent Technologies
representative. For detailed circuit pack descriptions, refer to Designing the Avaya
S8700 Media Gateway for Multi-Connect Configuration.
Check the S8700 Multi-Connect configuration adjuncts for damage and report all
2
damage according to local shipping instructions.
Red-tag all defective and over-shipped equipment and return to the nearest Material
1
Stocking Location (MSL).
For Avaya Order Exception in the United States, call 1-800-772-5409. For international
customers, contact your order service agent.
2 Direct all short-shipped reports to the nearest MSL.
Contact the appropriate location for specific instructions.
Installing an Avaya SCC1 Media Gateway Stack
May 2002
Installing the S8700 Multi-Connect 79