Verify Media Server 2 Connection To Customer's Lan - Avaya S8700 Installing Manual

15 Click through the Review Notices to get to the Set Server Identities page .
NOTE:
Most of the fields are populated with default settings. Do not change the defaults unless
the customer requests it (refer to the filled-out Job Aid entitled Pre-Installation Network
Worksheet—S8700 Multi-Connect).
16 Fill in the fields on the Set Server Identities and the subsequent pages:
• Configure Ethernet Interfaces
• Configure Switches
• Set DNS/DHCP
• Configure Time Server
Set Modem Interface
•
Update System
•
NOTE:
The server is not configured until you click Continue on the Update System page.
When you complete all the fields, the Update System screen displays each configuration
17
task as it completes it. The last line says "System modifications completed."
Scroll down to view the software release number.
18
If the software release is the expected release, go to
customer's LAN'' on page
If it is not the expected release, go to
Avaya™ S8700 Media
Verify media server 2 connection to customer's
LAN
The following administration is done on the services laptop computer connected to media server
2 using the S8700 Media Server Web Interface. You also need a customer representative with
knowledge of the customer's LAN configuration and access to a desktop on the non-dedicated
network.
1 Connect a customer-supplied CAT5 cable from media server 2, port Eth4, to the
customer's LAN. Refer to
Multi-Connect Configuration.
2 On the S8700 Media Server Web Interface click on Execute Ping
3 Have the customer enter a name, if DNS is administered, or IP address.
4 Verify that the ping executes successfully and a response is returned from the target host.
31.
Upgrading Software on an Initial Installation of an
Server.
Getting Started with Avaya S8700 Media Server for
May 2002
Installing the S8700 Multi-Connect
Configure the Hardware in the Rack
''Verify media server 2 connection to
31