Install Cables Between Media Gateway And Mdf - Avaya S8700 Installing Manual

156 Installing the S8700 Multi-Connect
Patch Cord/Jumper Installation and Administration
3-Pair Modularity for Trunk Pairs for 3-Pair Tie Trunks
Figure notes
1
2

Install Cables Between Media Gateway and MDF

1
2
3
4
5
6
7
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
Green Field
1-Pair Jumpers
Install D rings on the wall between the cable slack manager and the terminal/connecting
blocks mounted on the MDF.
Install a self-adhesive port label on the back of each connector on the connector cable.
Position the labels so the media gateway connector retainers do not cover them.
At the rear of the media gateway, connect 1 end of the connector cable to the assigned
connector.
Route the cable down the rear of the media gateway, through the cable slack manager,
and to the MDF.
At the MDF, connect the other end of the cable to the assigned terminal/ connecting
block connector.
Store the cable slack in the cable slack manager.
Repeat Steps 2 through 6 until all cables are installed.
3
13
1 2 3 4 5 6 7 8 9 10 11 12
Pairs
3
Purple Field
4
May 2002
14 15 16 17 18 19 20 21 22 23 24
r758537b MMR 031496