Check Circuit Pack Configuration - Avaya S8700 Installing Manual

284 Installing the S8700 Multi-Connect
Testing the Complete Configuration
Sample Port Network Status Screen for Cabinet 1—S8700 Multi-Connect
status port-network 1
PN Alarms Alarms Alarms
1
TDM Service
Bus
A
B
Command:

Check Circuit Pack Configuration

The list configuration report provides a list of circuit packs connected to the configuration and
recognized by the software.
1
2
3
4
Major Minor Warning Carrier
1 0 195
Control Dedicated
State Channel Tones
in y
in n
Service
PKT State
1 in
Type list configuration all and press
Verify the screen displays list configuration similar to
Screen — Page 4, S8700
each circuit pack (except power supply circuit packs). Do not attempt to correct any
problems until after the diagnostic tests that you run later in the configuration tests.
Note any boards with a VINTAGE column entry of NO BOARD or CONFLICT.
A u indicates unassigned ports, and a number indicates the port has been translated.
PORT NETWORK STATUS
PN Control
Locs Active Standby
01A up up
01B
TONE/
CLOCK
n 01B
y 01A
Major Minor Bus
Alarms Alarms Faults
n n
.
Enter
Multi-Connect". Make sure the software is communicating with
May 2002
FIBER-
LINK Endpoints
1 B-PNC 01B02-03E04 standby
1 A-PNC 01A01-01E04 active
Service System
State Clock
in standby
in active
Open Bus
Leads
0 0
"Sample System Configuration
Mode
System
Tones
standby
active