Avaya S8700 Installing Manual page 259

Prompt = [IPADMIN]:
Type set control interface <ipaddr><netmask>, where <ipaddr>is the
8
customer-provided IP address and <netmask> is the customer provided subnet mask.
Press .
Enter
9 If required type set control gateway <gateway>, where <gateway> is the
customer-provided IP address for their gateway. Press
10 If required use the set vlan priority, set vlan tag, set vlan id and set diffserv commands
to enter VLAN and diffserv parameters for the IPSI. Use the help <command> to obtain
syntax guidelines for these commands.
Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
11
"IP Server Interface
Type quit to logoff the IPSI.
12
NOTE:
Control network settings (IP address, subnet mask, and gateway) will be placed into effect
when the user exits the IPADMIN session.
13 Disconnect the laptop from the faceplate.
NOTE:
Always use the arp -d 192.11.13.6 command (see step four) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop will appear
to 'hang' and will not connect to the next IPSI.
14 Repeat for each IPSI circuit pack.
LEDs")
CLK
S
E
R
V
May 2002
Installing the S8700 Multi-Connect
Connect the Hardware
Enter.
259