Install Sneak Fuse Panels - Avaya S8700 Installing Manual

164 Installing the S8700 Multi-Connect
Patch Cord/Jumper Installation and Administration

Install Sneak Fuse Panels

(For general information, see
The ''Model 507B Sneak Fuse Panel'' on page
current protection. The panel contains two 25-pair connectors, fuse removal tool, and fifty
220029 sneak fuses (and two spares). See
pinout data.
1
2
3
4
5
6
Model 507B Sneak Fuse Panel
Figure notes
1
2
3
Locate the 507B near the network interface or the Main Distribution Frame (MDF).
Hold the panel against the mounting surface and mark the mounting screw locations.
Drill pilot holes at the marked locations and partially install a locally obtained #12 x
3/4-inch screw into the two bottom mounting slots.
Slide the sneak fuse panel onto the mounting screws and tighten the screws securely.
Install a locally obtained #12 x 3/4-inch screw into the top two mounting slots and
tighten securely.
Repeat the procedure for each sneak fuse panel.
Secure the B25A cable to the panel with the captive screw on the connector and a
supplied cable tie.
Sneak Fuse Panel
25-Pair Male Connector (In)
25-Pair Female Connector (Out)
''Sneak Fuse Panels'' on page
164, or equivalent, is recommended for sneak
''Sneak Fuse Connector Pinout'' on page 165
Sneak
Current
Protector
507B
sneak CJL 032096
4
May 2002
127.)
220029 Fuses (Inside Panel). Use
small screwdriver to pry top cover off.
for