Avaya S8700 Installing Manual page 181

Backplane Adapter
Figure notes
Amphenol connector attaches
1
to the back of the media
gateway, corresponding to the
TN2501AP circuit pack slot.
Installing the TN2501AP Circuit Pack
!
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a grounding strap while handling
the circuit pack.
Insert the circuit pack into any port slot and close the latch securely.
1
At first, the red and green LEDs are on steady, then the green LED flashes. If there are
announcements on the circuit pack, the amber LED flashes while the announcements are
copied from FLASH to RAM. After about 3-5 minutes, all of the top 3 LEDs go out,
although the time is longer if there are announcements already recorded on the circuit
pack.
NOTE:
If the TN2501AP circuit packs are at the MultiVantage software limit and you insert a
VAL circuit pack, the red LED on that circuit pack stays on, indicating that the
MultiVantage software does not accept it.
2 Connect the backplane adapter to the Amphenol connector on the back of the media
gateway corresponding to the TN2501AP circuit pack slot.
Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.
3
3
1
addfipm2 KLC 083000
2
3
May 2002
Installing the S8700 Multi-Connect
Connecting to the Customer's Network
2
RJ45 LAN cable connection
10 Mbps uses Category 3 cable.
•
• 100 Mbps uses Category 5 cable.
This connector is not used for VAL.
181