Avaya S8700 Installing Manual page 256

256 Installing the S8700 Multi-Connect
Connect the Hardware
NOTE:
If you have only one multi-connect configuration, the default switch ID is A, which was
administered earlier. The second configuration would be B and so on. The switch ID is not
the carrier letter.
3
NOTE:
If you pass up the letter/number you want, you must either cycle through all the
letters/numbers to get to the letter/number you want or reinsert (reseat) the circuit pack
and start at the beginning.
NOTE:
The number to program is the cabinet number not the port network number. If you have
more than one IPSI in a cabinet, they all have the same cabinet number even if it is a split
cabinet with 2 or more port networks.
4
5
While the display is flashing, press the button until the switch ID (A through J) shows on
the top character of the LED display. When the correct letter shows, stop. It will flash a
few times (5 seconds) then stop. The next character down will begin to flash.
While the first digit of the cabinet number is flashing, press the button until the correct
tens digit (0 through 6) shows on the display. When the correct number shows, stop. It
will flash a few times then stop (five seconds). The second digit of the cabinet number
will begin flashing.
While the second digit of the cabinet number is flashing, press the button until the correct
units digit (0 through 9) shows on the display. When the correct number shows, stop. The
units digit will flash a few times then stop (five seconds).
CLK
S
E
R
V
May 2002