Avaya S8700 Installing Manual page 102

102 Installing the S8700 Multi-Connect
Installing an Avaya SCC1 Media Gateway Stack
Use the front ground plate instead of the media gateway clip to attach the media gateways to
each other. Use one front ground plate between two stacked media gateways.
1
2
3
4
Rear Ground Plate and Front Plate or Media Gateway Clip — Side View
Figure notes
1
2
3
At the front of the media gateways, align the holes in the top of the front ground plate
with the holes at the bottom of the upper media gateway, and insert the four screws. Do
not tighten the screws yet. See
Clip — Side View'' on page
At the front of the media gateways, align the holes in the bottom of the front ground plate
with the holes at the top of the lower media gateway. Insert the four supplied #12-24 x
1/2-inch (1.27 cm) thread-forming screws. Do not tighten the screws yet.
Repeat Steps 1 and 2 until all stacked media gateways are fastened together.
Tighten all screws securely.
1
2
Front Ground Plate or Media Gateway Clip
Battery
Rear Ground Plate
''Rear Ground Plate and Front Plate or Media Gateway
101.
May 2002
3
grdpltec LJK 031096