Install Sneak Fuse Panels - Avaya S8700 Installing Manual

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway

Install Sneak Fuse Panels

For general information, see
The ''Model 507B sneak fuse panel'' on page
current protection. The panel contains two 25-pair connectors, fuse removal tool, and fifty
220029 sneak fuses (and two spares). See
pinout data.
1 Locate the 507B near the network interface or the Main Distribution Frame (MDF).
Hold the panel against the mounting surface and mark the mounting screw locations.
2
Drill pilot holes at the marked locations and partially install a locally obtained #12 x
3/4-inch screw into the two bottom mounting slots.
3 Slide the sneak fuse panel onto the mounting screws and tighten the screws securely.
4 Install a locally obtained #12 x 3/4-inch screw into the top two mounting slots and
tighten securely.
5 Repeat the procedure for each sneak fuse panel.
Secure the B25A cable to the panel with the captive screw on the connector and a
6
supplied cable tie.
''Install Sneak Current and Off Premise Protection'' on page
137, or equivalent, is recommended for sneak
''Sneak fuse connector pinout'' on page 138
May 2003
139
136.
for