Siemens SINUMERIK 840DE sl Commissioning Manual page 266

Tool management
12.6 Editor for the tool and magazine management
Element values
You can change the magazine location type with the parameters in the "Location" window:
Parameters
Location type
Consider adjacent location
12.6.3.5 Link assignments
You can establish the mechanical relationship between the individual components of the tool
unit in the "Assignment" window.
Element values
You are currently located under the "Active data" → <tool unit> directory in the "Commissioning"
→ "NC" →"Tool management" operating area.
You can link the following parameters with each other from the selection list via the
Assignments element:
● Spindle/gripper/loader for magazine
● Gripper/loader for spindle
● Loading point for magazine
Note
The separation as number of locations from the magazine zero point of the affected magazine
to the internal magazine location must be defined for each magazine assignment.
Example
If, for example, tools on a spindle must be replaced from a magazine, the following assignment
can result:
252
Description
Identification for the magazine location type
● Yes
● No
Location
1 Tool spindle
2 Gripper
3 Gripper
4 Transfer location
1 Load station
2 Load station
Magazine
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Type/Index
Spindle_1
Gripper_1
Gripper_2
Transfer_location_1
Load_station_1
Load_station_2
Magazine_1
SINUMERIK Operate (IM9)